| Subject | Text |
| the only other way i use to enter the service mode is via the sony trace interface, replacing the ee |
| Follow the trace to the next component and put a jumper in. |
|
|
| Combining mixer outputs | I have been running a mixer for live bands & karaoke for years combining the left & right ou |
| Sony STR-11S Datasheet | Hi,
I have an old (~15 years) Sony amp with a blown speaker output. Any ideas how I could find t |
| Fourth, when you press the shutter release button can not take pictures
1. Just take pictures of t |
| Toshiba 3787DB - Very low Base / Woofer output | Getting a very low output on the sub woofer, with the sub and the base turned all the way up you can |
| :idea: Found the following:
1) C951 = 4.7ufd/250V
2) Suggest changing these caps in standby po |
| Service mode:
With TV ON Press simultaneously OSD button on TV panel and
Standby button On remot |
| How to protect the CD-R? | 1.The main influence to the durability of CD-R
Temperature and humidity are the most basic and |
| Hi,
The situation is very much the same here (in Bulgaria) - same new stores, which give credit, |
| [quote:e6a73c2eac="opal"]Thanks for the Info,
i have to addmit, im not into Musik really, so i dont |
| [quote:780ca32676="Justmanuals"]This Parts & Service manual can now be purchased for $11.77 and |
| Convergence IC's in this case are dual amplifiers. On IC does red and half of green. The other IC do |
| Have you attempted a degaussing of the screen? | Have you attempted a degaussing of the screen? If this helps trace down and check the the thermister |
| Re: Ilo 32 quick inverter question... | Not familiar with the specifics of the set but, for the balast-on line, I would say 1.49 is too low |
| Fujitsu PDS4234 42 Plasma Failure - Blinking RED light | Hi,
I got a Fujitsu PDS4234 42 Plasma and till now it worked fine since 2003.
Now I encountere |
| Sears 509-14370 TV, chassisA67 | Sears 509-14370 TV, chassisA67, made by JVC, the board is labeled CKF0822-DU3-1. TV turns on when f |
|
|
| Speakers and wiring are good. The distortion is there regardless of input - whether internal (tuner) |
| Capacitior help! | I need to replace two capacitors in a TV that i can see are visibly leaking,i've replaced all the ot |
| NOKIA2130HS-service mode?. | I am looking for information about service mode and hotel mode unlock for
TV NOKIA2130HS(HOTEL TV) |
| Re: Viewsonic N3245W Black Screen - Need some help | I would like your old inverter board; have one with bad transformer on; can't find supply of board o |
| Re: peugeot radio code | [quote:da7380a6aa="masterskay62"][quote:da7380a6aa="vunjko"]peugeot 206 serial CL0410Z0151554. MOD |
| Samsung 760V TFT Lower Half of Screen Darker than Top Half | This happens every so often and I have to turn the monitor off and on and it fixes it, works fine af |
| JVC AX-22 Service manual | I need service manual for JVC AMPL. Model AX-22.Please help!!! |
| Vizio L32 | RTek,
thanks for the help. I had to put this one on the shelf for a bit. My current problem is t |
| [quote:5a5876d182="Anonymous"]I traced back to the input of the motor control IC (SIP #BA6209N) pins |
| I need schematic diagram of Sony ericsson t68i | power ways are cut off. i need it to trace and make jumpers for its positive ways. can you share p |
| Request - Service Manual of Lanier 6112 | Can anyone help me with this model?
I burn-out the board and wanted to trace the pcb-side for par |
| resolder all joints in the line output stage, check R629 (27ohms, 1/2w 90 degree tube)(2.7ohms, 1/2w |
| There really are so many variables to even attempt to guess at the problem... the guy who gave it to |